S&S Cycle Motorcycle Accessories Manual de servicio Pagina 1

S&S Billet Pro Stock Engine Assembly – #31-9710High-performance off road only!S&S #31-9710 S&S Billet Pro Stock EngineAssembly – Complete,

101121171014398546213S&S BILLET PRO STOCK ENGINE ASSEMBLY – 31-9710LOWER END PARTSPRO STOCK PRIMARY COVER1. Clutch cover with hardware ...

S&S BILLET PRO STOCK ENGINE ASSEMBLY – 31-9710CYLINDER HEADS AND PARTSPRO STOCK HEAD ASSEMBLY1. Head AssemblyFront head assembly...

S&S BILLET PRO STOCK ENGINE ASSEMBLY – 31-9710PISTON PARTS1. Piston set,Standard-Includes wristpins and rings...92-4925Oversize (.005

20. Fuel pump ...50-504221. Fuel pressure regulator...

5615518251131472436595325242340373938373630323529342952484763495010495018141922541S&S BILLET PRO STOCK ENGINE ASSEMBLY – 31-9710TRANSMISSION PARTS

142114201914181716151446626160581211262227222829303130323346454243444159571213S&S BILLET PRO STOCK ENGINE ASSEMBLY – 31-9710Continued...16. Spline

16Because every industry has a leader

Designed by S&S Cycle, Inc. and exclusively distributed and serviced through G2 Motorsports..SAFE INSTALLATION AND OPERATION RULES:Before installi

S&S BILLET PRO STOCK ENGINE 31-9710 The S&S Billet Pro Stock is the same engine you’ve seen used incompetition at NHRA and AHDRA races. It is

Pinion Gear Nut ...90 ft-lbUse 609 green Loctite liberally on gear and nut--especially on

MAINTENANCE TIPSVISUAL INSPECTION AFTER EACH RUN ● Moly valve coating for cracking or flaking● Bottom spring collar for cracks.● Valve tips, lash caps

REPLACING THE DRIVE SIDE CRANK MAIN BEARINGIt is recommended that the left (drive side) main bearing bereplaced during normal engine teardown maintena

13. Use the old bearing as a spacer and drive gear as a push tooland put in the 3 screws that hold the starter drive on andbegin pulling the bearing i

S&S BILLET PRO STOCK ENGINE ASSEMBLY – 31-9710LOWER END PARTSPRO STOCK CRANKCASE ASSEMBLY1. Crankcase assembly with cam chest...

79810121151513143254513556BILLET PRO STOCK ENGINE ASSEMBLY – 31-9710LOWER END PARTSPRO STOCK CAM CHEST1. Cam set (must be degreed and welded) ...